Tatu Marchesan PMT, Operator'S Manual

Page: 30 / 62

28
PMT - Rev. 05 - Sep/22
- Only CAPABLE and AUTHORIZED personnel must carry out the adjustments and
operations of the equipment.
- Observe every safety condition and use safety glasses, foot protection, earplugs/
muffs, protective gloves and any other required PPE.
- Do not carry out any adjustment while the equipment is working.
ATTENTION! RISK OF ACCIDENT
7. Adjustments and operations
Corn head equipped with telescopic cardan.
Verify the length of the cardan shaft in the following way:
1) Separate the male bar from the female tube and couple it in the power take-off. For
this, turn the quick lock on clockwise direction and push it to fit on the coupling lock device.
Then, loosen up the lock and pull it to confirm the locking.
2)
Steer the tractor wheel until it gets closer to the drawbar (approximately a
70 degree
angle). Being the cardan shaft bars placed side by side, verify the existence of a minimum
free space of five to seven centimeters.
Cardan length adjustment
5 to 7 cm 5 to 7 cm
5 to 7 cm 5 to 7 cm
70º 70º
NOTE
- At this moment, it is possible to use the tractor drawbar adjustments to shorten or
to lengthen it.