Tatu Marchesan PMT, Operator'S Manual

Page: 35 / 62

33
PMT - Rev. 05 - Sep/22
Auger gearbox replacement
7. Adjustments and operations
A A
B B
C C
D D
E E
F F
H H
I I
J J
K K
L L
G G
ATTENTION
- Repeat this process on the other side of the equipment.
To change the auger speed, follow the steps below:
- Remove the rear lid (A) loosening up the bolts (B), spring washers, flat washers and
cotter pins (C);
- Loosen up the side lid (D) which is fastened by the bolts (E), flat washers and nut;
- Loosen up the bolt (F), spring and flat washer that fasten the sprocket (G) on the
auger axle;
- Replace the sprocket (G) to the desired one.
- Loosen up the lid (H) loosening up nuts and flat washers;
- Remove the axle (I) loosening up the bolts (J) and leaving the drive (K) and driven
(L) shafts free to be replaced.