Tadano TT-800XXL1, Service Manual

Page: 154 / 267

K-1 K-1
Crane Cab Glass
1
W587-0011E
Crane Cab Glass
1. Glass replacement procedure
Follow the procedure described below to replace
the fixed windshield window glass, roof glass,
front right window glass (quarter window glass)
and rear right window glass of the crane cab.
1. Remove the glass to replace and the adhesive
from the cab body, and clean the window opening
surfaces.
2. Fit a trim all around the glass bonding frame of the
cab body.
[NOTICE]
Make adjustments so that the glass and the rubber
dam of the trim will make even contact with each
other.
3. Temporarily set a new glass on the cab, attach
pieces of masking tape across the glass and
frame in more than two places to mark their
relative positions, and then remove the glass.
(Example) Roof glass
Front
Roof
Masking tape (for position marking)
IW587-0010E01
4. Clean and degrease the glass bonding surfaces of
the cab body with a new gauze soaked with white
gasoline or acetone. Wait for more than a minute
to let them dry.
[NOTICE]
Shake the primer bottle well and then apply the
primer with a brush, while making sure that there is
no portion left uncoated.
Prevent the primer coated surfaces from any
contact with hand, brush hairs, dust, water drops,
etc.
The primer deposited on a surface other than the
glass bonding surfaces should be immediately
wiped away with a cloth soaked with white gasoline.
5. Apply a 5 to 20µm (0.0002 to 0.0008 inch) thick
coat of primer C to the glass bonding surfaces of
the cab body.
• Primer C:
AR Primer for cab (clear)
Cemedine Co., Ltd.
6. Let the primer C coated surfaces dry for more
than 15 minutes.
7. Clean and degrease the bonding surfaces of the
new glass with a gauze soaked with white
gasoline or acetone.
Leave it more than 1 minute to dry.
[NOTICE]
Shake the primer bottle well and then apply the
primer with a brush. While making sure that there is
no portion left uncoated or blurred, apply the primer
evenly.
Prevent the primer coated surfaces from any
contact with hand, brush hairs, dust, water drops,
etc.
The primer deposited on a surface other than the
glass bonding surfaces should be immediately
wiped away with a cloth soaked with white gasoline.
8. Apply 5 to 20µm (0.0002 to 0.0008 inch) thick coat
of primer B to the non-ceramic coated portion on
the outer circumference of the new glass.
• Primer B:
AR Primer for glass (black)
Cemedine Co., Ltd.
IW587-0011E01
Apply
Ceramic coating
Glass
[15 mm (0.59 in)]
9. Let the primer B coated surfaces dry for more
than 15 minutes.
[NOTICE]
Apply the POS seal to the cab interior side of the
molding, to a point inner than the center.
10. Apply the POS Seal (Cemedine product) to the
glass fitting groove of the molding.
IW587-0010E03
Interior
Exterior
(Glass)
Seal Molding POS