Tadano TT-800XXL1, Service Manual

Page: 128 / 267

19
W537-0 1 0 1 E
G-3. G-3.
Jib
2.3 Adjusting inclination of jib 2
Adjust the inclination to facilitate inserting and
removing the jib 1 -2 connecting pin.
1 ) If the rear end of the jib 2 is too low for the pin to
be inserted and removed easily, apply shims (t0.6
mm (t0.02 in)) to the slide plate on the support on
the boom rear end.
2) If the rear end of the jib 2 is too high for the pin to
be inserted and removed easily, remove a shim
(t0.6 mm (t0.02 in)) one by one from the slide
plate on the support on the boom rear end until
the pin can be inserted and removed easily.
3) Add or remove shims (t0.6 mm (t0.02 in)) on the
support on the boom rear end and shims (t3 mm
(t0.
1 2 in)) on the center support of the jib 2 to
facilitate the jib 1 -2 connecting pin.
[NOTICE]
Boom rear end support: The rear end of the jib 2 is
raised when shims are added; lowered when shims
are removed.
Center support on jib 2: The rear end of the jib 2 is
lowered when shims are added; raised when shims
are removed.
IW537-0 1 00E05
Support on boom rear end
Shim (t 0.6)
Slide plate