Tadano TM-2000-1, Service Manual, Page: 102 / 194

G - 2
Boom (Five-section boom)
27
W536-1040E
G - 2
12. Adjust the clearances of the slide plates on the
side faces of the boom based on the dimension
measured at step 9.
Adjust the clearances to the following by
increasing or decreasing the number of shims.
- 0.5 mm (1/64 in) or less in total when the values
at right and left are added
[NOTICE]
After this adjustment, apply thread locker
(ThreeBond 1305) to screws that are used for fixing
the slide plates.
Then lightly tighten the screw and back off a quarter
turn.
13. Apply grease to the surfaces outside the 3rd
boom section on which the slide plates of the 2nd
boom section slide and the slide plates at the rear
end of the 3rd boom section.
14. Pass the temporary cord through the roller assy
and fix the roller assy at the rear end of the 3rd
boom section.
15. While pulling the temporary cord to the rear of the
boom, insert the 3rd boom section into the 2nd
boom section to the point about 2 m (6.6 ft) before
full retraction.