Swatch Lasag SLS 200 CL Series, Service Instructions Manual

Page: 193 / 347

I N D U S T R I A L - L A S E R S
A COMPANY OF THE
I N D U S T R I A L - L A S E R S
A COMPANY OF THE
Service instructions
Laser sources with LOS
10 Adjustment and description fiber-optic
cable coupling LOS
© Lasag AG, Thun, 15.05.08 CM
86 . 0629 - 10 - 10
35. Set the Fiber Status to 2.
36. Position the fixed mirror F2 in such a manner with the fixing screws item 2, that the pilot laser beam
on the one hand passes through the adjusting aid item 3 in station No.2 and simultaneously is po-
sitioned approx. within the cross-hairs of the target cross-hair template.
37. Tighten the screws item 2 well and observe, whether the pilot laser beam remains the same on the
target cross-hair template.
38. Fine adjustment of the pilot laser beam in the target cross-hair template No. 2 by means of the ad-
justing screws item 1 of the fixed mirror F2.
39. Verification as to whether the pilot laser beam is positioned centred relative to the adjusting aid and
to the target cross-hair template. Change the Fiber Status and verify this once more.
40. If point 39 is not fulfilled, then continue at point 35.
41. Set the Fiber Status to 3 and adjust the fixed mirror F3 the same way as the fixed mirror F2
(points 36 - 40).
42. Set the Fiber Status to 4 and adjust the fixed mirror F4 the same way as the fixed mirror F2
(points 36 - 40).
43. Select Fiber Status 1 – 6 and verify, that the pilot laser beam impinges on the target cross-hair
template No. 1 - 6 centred.