STEERING COLUMN CONTROLS
60A 23-03030
HAZARD WARNING SWITCH
Turn Signal Operation
With the ignition switch in the "ON" posi-
tion, move the lever up or down to ac-
tivate the right or left turn signals.
Normal Turn Signal
Move the lever all the way up to
signal a right turn or all the way down
to signal a left turn. When the turn is
completed, the signal will cancel and
the lever will return to its normal posi-
tion.
Lane Change Signal
In some turns, such as changing lanes,
the steering wheel is not turned far
enough to cancel the turn signal. For
convenience, you can flash the turn
signal by moving the lever part way
and holding it there. The lever will
return to its normal position when you
release it.
60A23-03040
WINDSHIELD WIPER AND WASHER
LEVER
Push down the hazard warning switch to
activate the hazard warning lights. All four
turn signal lights and both turn signal in-
dicators will flash simultaneously. To turn
off the lights, push the switch again.
Use the hazard warning lights to warn
other traffic during emergency parking or
when your vehicle can otherwise become
a traffic hazard.
Windshield Wipers
To turn the windshield wipers on, twist
the knob on the end of the lever to one
of the three operating positions. In the
"INT" position (if equipped), the wipers
operate intermittently (once every 3 to 5
seconds). The "INT" position is very con-
venient for driving in mist or light rain. In
the "LO" position, the wipers operate at
a steady low speed. In the "HIGH" posi-
tion, the wipers operate at a steady high
speed. To turn off the wipers, twist the
knob back to the "OFF" position. To wipe
mist off the windshield, you can operate
the wipers for just a few cycles by
pushing down on the wiper and washer
lever. The wipers will operate without
spraying washer fluid until you release the
lever.
27
3-4
