CHASSIS 5-51
TUBE
• Inspect the tube after the tire is removed from the rim.
• If the tube has abnormality, replace the tube with a new one.
TIRE INSTALLATION
• Apply tire lubricant to the tire bead.
!
• Install the tube.
• When installing the tire onto the wheel, observe the following
points.
• When installing the tire, the arrow
1
on the side wall should
point to the direction of wheel rotation.
• In case of a new tire, align the light point mark
2
on the tire
side wall to the valve hole to balance the tire and wheel.
• Align the chalk mark put on the tire at the time of removal with
the valve position.
• For installation procedure of tire onto the wheel, follow the
instructions given by the tire changer manufacturer.
• Be careful not to catch the tire.
• Bounce the tire several times while rotating. This makes the
tire bead expand outward to contact the wheel, thereby facili-
tating air inflation.
• Inflate the tire.
(
Do not use oil, grease or gasoline on the tire bead in
place of tire lubricant.
* Do not inflate the tire to more than 400 kPa (4.0 kgf/
cm
2
). If inflated beyond this limit, the tire can burst
and possibly cause injury. Do not stand directly over
the tire while inflating.
* In the case of preset pressure air inflator, pay special
care for the set pressure adjustment.
Summary of Contents for RV125
