CHASSIS 5-33
• Turn the steering stem bracket about five or six times to the
left and right so that the bearings seat properly.
• Loosen the steering stem nut ¼ – ½ of a turn.
• In this condition, check that the steering stem can turn
smoothly with no rattle and stiffness.
• If there is a rattle or heavy movement, adjust the tightness by
the stem nut.
NOTE:
This adjustment will vary from motorcycle to motorcycle.
• Before tightening the steering stem head nut, temporarily
install the front forks.
• Tighten the steering stem head nut
1
to the specified torque.
'
Steering stem head nut: 90 N·m (9.0 kgf-m)
• Install the front forks. (
#
5-26)
• Install the handlebars. (
#
5-19)
• Install the speedometer.
• Install the headlight housing and headlight.
• Pass the turn signal lead wires
2
and speedometer cable
3
through the guides
4
.
• Install the front wheel. (
#
5-8)
!
¼ – ½ turn
Check that the cable or wire harness does not prevent
the handle operation.
Summary of Contents for RV125
