ENGINE 3-39
STARTER CLUTCH AND STARTER DRIVEN GEAR BEARING
STARTER CLUTCH
Install the starter driven gear onto the starter clutch and turn the
starter driven gear by hand (the gear turns in only one direction).
The starter driven gear should turn smoothly. If excessive resis-
tance is felt while turning the starter driven gear, inspect the
starter clutch. Also, inspect the surface of the starter driven gear
which contacts the starter clutch, for wear or damage. If any
wear or damage is found, replace the defective part(-s).
STARTER DRIVEN GEAR BEARING
Install the starter driven gear bearing
1
and gear
2
onto the
crankshaft and turn the starter driven gear by hand. Inspect the
starter driven gear bearing for smooth rotation and any abnor-
mal noise. If the bearing does not turn smoothly or there is any
abnormal noise, replace it.
DISASSEMBLY
• Remove the starter driven gear.
• Remove the roller
3
, spring
4
and push piece
5
.
10 N.m
(1.0 kgf-m)
Starter driven gear
Roller
Push piece
Spring
Generator motor
Summary of Contents for RV125
