Suzuki Jimny, Manual

Page: 186 / 476

3-33
OPERATING YOUR VEHICLE
78RB1-01E
Lane departure warning
When you are operating at a speed of
approximately 60 km/h (37 mph) or over
and the dual sensor judges that your vehi-
cle is to deviate from the running lane, the
following warnings will work.
• The lane departure warning indicator
light will blink
• A message will appear on the informa-
tion display
• The steering wheel will vibrate
78RB03036
Situations where the system does not
activate
Under the following situations, the system
does not activate.
• When dual sensor brake support indica-
tor light and lane departure warning indi-
cator light are initially lighting
immediately after the ignition switch is
turned to “ON”
• When the following switches are pushed
and the system is turned off:
– Lane departure warning OFF switch
– ESP
®
OFF switch
• When operated the hazard warning
switch
• When the dual sensor is temporarily
stopped or malfunctioning
• When the system judges that the inten-
tional lane change, such as during or
after flashing the turn signal lights
Situations where the system may not
activate properly
Under the following situations, the system
may not activate.
• When you suddenly close to the partition
lines
• When driving on sharp curves
• When you do not return to inside of the
lane after the lane departure warning is
activated
• When the electric power steering light
comes on
If the dual sensor cannot detect partition
lines except for above situations, the sys-
tem may also not activate. Refer to “Situa-
tions where the dual sensor may not
activate properly” in this section for details.
Indicator
light
Information
display
WARNING
• The lane departure warning may
not be suitable for every situation.
Also, the system is not designed to
avoid the lane deviations automati-
cally. Do not rely excessively on
the system and always drive in a
safe manner.
• Depending on road surface condi-
tions, you may not feel the vibra-
tion of the steering wheel even
when the lane departure warning
works.
• For safety reasons, do not check
the operation of the system by
yourself.