Suzuki Jimny, Manual

Page: 177 / 476

3-24
OPERATING YOUR VEHICLE
78RB1-01E
Changing cruising speed
Using the accelerator pedal
To reset at a faster cruising speed, acceler-
ate to the desired speed using the accelera-
tor pedal and push down the “RES +/SET –”
switch (3). The new speed will be main-
tained.
Using the brake pedal
To reset at a slower cruising speed, decel-
erate to the desired speed using the brake
pedal and push down the “RES +/SET –”
switch (3). The new speed will be main-
tained.
NOTE:
When the brake pedal is depressed, “SET”
indicator light (5) or set indicator (7) goes
off until the cruising speed is reset.
Using “RES +/SET –” switch
To reset at a faster cruising speed, press
repeatedly or hold push up the “RES +/
SET –” switch (3). Vehicle speed will
steadily increase. When you release the
switch, the new speed will be maintained.
To reset at a slower cruising speed, press
repeatedly or hold push down the “RES +/
SET –” switch (3) until the vehicle has
slowed to the desired speed, and then
release the switch. The new speed will be
maintained.
NOTE:
You can adjust the set speed by approxi-
mately 1 km/h (1 mph) by pushing “RES +/
SET – ” switch quickly.
Cancelling cruise control
“SET” indicator light (5) or set indicator (7)
will go off and the cruise control will be
canceled temporarily with the following
conditions:
• Push “CANCEL” switch (2).
• Depress the brake pedal.
• For manual transmission vehicle, depress the
clutch pedal.
• For automatic transmission vehicle, the
gear position is changed to “L”
• When the transfer lever is operated,
• The vehicle speed falls more than about
20 percent from the set speed.
• Any time the vehicle speed falls below
40 km/h (25 mph).
• When the vehicle skids and ESP
®
is
activated.
To resume the previously set speed, push
up the “RES +/SET –” switch (3) and turn
on “SET” indicator light (5) or set indicator
(7). The vehicle speed must be above 40
km/h (25 mph) when the vehicle is not
under the above conditions.
To turn off the cruise control system, push
cruise switch (1) and check that the cruise
indicator light (4) or cruise indicator (6)
goes off.
Also, if the malfunction indicator light in the
instrument cluster comes on or blinks, the
cruise control system will be turned off.
NOTE:
If you turn off the cruise control system, the
previously set speed in the memory is
cleared. Reset your cruising speed again.