Doc. Title
Author
Page of Pages
ST300/340 OPERATION MANUAL
– LATAM
HG.Park
44 of 146
Concerning
Doc. No.
Rev.
Date
Features and How to set parameters
1.41
26 May. 2015
Suntech International Ltd.
Confidential Document
4-16. Polygon geo-fence parameters
4-16-1. How to set polygon geo-fence for each group
Each polygonal geo-fence group setting can make a sequential progress only with the sequential command packet.
The command flow is as below.
(1
st
) Set Polygon Group +
(2
nd
) Whole Command of Set Polygon Po ..
(last) Set Polygon Group Enable/Disable
Polygon group setting can be completed by Set Polygon Enable/Disable command.
If the next command cannot reach within 10minutes after receiving the last command, the setting procedure ends
automatically and
‘Set Polygon Group command (1
st
step)
’ should be sent again for setting.
4-16-1-1. How to set Polygon Group (Sequential Command
– 1
st
)
Field
Marks
Value
Meaning
HDR
“ST300PLG”
Command type
DEV_ID
String
Device ID
VER
“02”
Protocol Version
CMD_NO
‘1’
Sequential number of series of commands
TOTAL_CMD_NO
Total number of series of commands
GROUP_ID
‘1’ ~ ‘10’
Polygon group ID
ALLOW_PARAM
‘0’ or ‘1’
If ‘1’, all the parameters of the following Fields of this Chapter
(i.e. Chapter 4-16-1-1) will be functional.
However, If ‘0’, all
the parameters will not be functional.
Some examples for these functions (i.e. Case 1 and Case 2)
are explained taken as follows:
Case 1:
<Case 1> is operational if you set the parameters to the
values as follows:
T2 (interval in driving) of Report Parameter=
120,
ALLOW_PARAM = 0, and
PT_INTERVAL_IN_DRIVING = 30
In the <Case 1> that the parameters have already been set
as above, the device sends the report at an interval of 30
seconds as soon as the vehicle gets into the pre-set geo-
fence territory (i.e. a vehicle in a driving mode). The device
will send a report every 120 seconds as soon as the vehicle
gets out of the geo-fence territory.
Case 2:
<Case 2> is operational if you set the parameters to the
