Sun Microsystems SunLink SNA 9.1 PU2.1, Configuration Manual

Page: 270 / 298

F-4 SunLink SNA 9.1 PU2.1 Server Configuration Guide—August 1997
F
F.2 sun3770/RJE Clients
The following table lists the Sun PU2.1 SNA Server configuration parameters
specific to sun3770/RJE clients that you must coordinate with the host
configuration. If you change any of these parameters in one configuration, you
must make the corresponding changes in the other configuration.
The NCP/VTAM gen lists all the SNA resources connected to an SNA
communications controller. The LU macro defines the characteristics of the
sun3770/RJE client attached to the corresponding LU port on the Sun PU2.1
SNA Server.
The LU type is determined by parameters that are transferred on the SNA bind
message during session establishment.
The following sample configuration shows the LU definitions for six
sun3770/RJE data streams.
**************************************************
*
* LU MACROS
*
**************************************************
BLU01101 LU LOCADDR=1,DLOGMOD=BATCH
BLU01102 LU LOCADDR=2,DLOGMOD=BATCH
BLU01103 LU LOCADDR=3,DLOGMOD=BATCH
BLU01104 LU LOCADDR=4,DLOGMOD=BATCH
BLU01105 LU LOCADDR=5,DLOGMOD=BATCH
BLU01106 LU LOCADDR=6,DLOGMOD=BATCH
In addition, the VTAM log-on mode (
LOGMODE
) tables require entries describing
the operating characteristics of logical units. The association between the LU
and its
LOGMODE
entry is created in the LU macro of the VTAM/NCP gen or in
the definition of a superior resource: group, line, or PU.
Table F-2 PU2.1 SNA Server 3770/RJE Configuration Parameters
Sun
Resource Resource
Parameter
Host Object
Host
Parameter
LU Local Address LU LOCADDR
Type LU
LOGMODE DLOGMOD
PSERVIC