65
C H A P T E R
6
Installing and Configuring
Sun StorEdge Volume Manager
This section contains guidelines for installing Sun StorEdge Volume Manager to
provide fault tolerant mass storage on the Netra ft 1800 system.
The main steps involved are:
1. Using
pkgadd
to load the Volume Manager packages, and install any required
patches.
2. Configuring the Volume Manager software as described in “Setting up the
Volume Manager Environment” on page 68.
3. Initializing the Volume Manager disk storage as described in “Initializing the
Volume Manager” on page 69.
Refer to the Sun StorEdge Volume Manager documentation for full information
about installing and using the Volume Manager, and to the Netra ft 1800 User’s Guide
for information about using the
cmsconfig
utility. (You use
cmsconfig
to obtain
the device name of the root disk when you add disks to your server.)
You perform all of the steps in this chapter as root.
Before You Install Sun StorEdge
Volume Manager
Sun StorEdge Volume Manager is installed on the Netra ft 1800 system in the same
way as other applications.
Summary of Contents for Netra ft 1800
