Sun Microsystems Fire X4800, Installation Manual

Page: 49 / 142

Figure Legend
4 An assortment of M6 and 10-32
screws
The screws are packaged by size and
type. They include:
■
12 – M6 X 16
■
12 – M6 X 12
■ 4 – M6 X 4 flathead
■
4 – 10-32 X 10
■
12 – 10-32 shoulder screws
Oracle provides extra screws to support different
configurations. Unused hardware can be discarded or
recycled when you have completed the installation.
5 Adapter brackets (2 sets of four each) These attach to the rack and support the shelf rails.
There are two sets of adapter brackets; one for round-hole
racks, and another for square-hole racks. Use the set that
matches your rack.
6 M6 cage nuts Used to attach the top rear braces to square-hole racks.
Installing the Server in a Rack Using the Universal Rack
Mounting Kit
This section provides instructions for installing your server in a rack. It includes:
■
“How to Remove Components to Reduce Weight” on page 49
■
“How to Replace the Components in the Server” on page 54
■
“How to Install the Rack Mounting Hardware in a Square-Hole Rack” on page 55
■
“How to Install the Rack Mounting Hardware in a Round-Hole Rack” on page 64
■
“How to Insert the Server Into the Rack” on page 72
Note –
The rack mounting kit does not include slide rails. Once the server is installed, it does not
slide in or out of the rack.
▼
How to Remove Components to Reduce Weight
This procedure describes how to remove components from your server so that two persons can
lift it into the rack. If you are going to use a mechanical lift, you do not need to perform this
procedure.
Installing the Server in a Rack Using the Universal Rack Mounting Kit
49