Sun Microsystems Fire X4800, Installation Manual

Page: 115 / 142

b. Type the default password:
changeme
.
The SP displays its default command prompt:
->
To display the SP IP address, type:
show /SP/network
Targets:
test
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = 10.80.193.10
ipaddress = 10.80.193.163
ipdiscovery = DHCP
ipgateway = 10.80.195.254
ipnetmask = 255.255.252.0
macaddress = 00:21:28:44:F4:EE
pendingipaddress = 10.80.193.163
pendingipdiscovery = DHCP
pendingipgateway = 10.80.195.254
pendingipnetmask = 255.255.252.0
state = enabled
switchconf = (none)
Commands:
cd
set
show
The ILOM displays network information, including the IP address.
Connecting to the ILOM
The ILOM has both a command line interface (CLI) and a web interface.
This section describes three different methods of connecting to the ILOM:
■
“How to Connect to the ILOM CLI Using the Serial Management Port” on page 115
■
“How to Connect to the ILOM CLI Using SSH” on page 116
■
“How to Connect to the ILOM Web Interface” on page 116
▼
How to Connect to the ILOM CLI Using the Serial Management Port
■
Perform the hardware setup as described in the hardware setup documentation.
■
Apply standby power to the server by connecting AC power. See “How to Apply Standby
Power for Initial Service Processor Configuration” on page 97 .
■
Verify that your terminal, laptop, or terminal server is operational.
Configure the terminal device or the terminal emulation software running on a laptop or PC to
the following settings:
3
Before You Begin
1
Connecting to the ILOM
115