Sun Microsystems Fire X4800, Installation Manual

Page: 43 / 142

Use the four long screws (M6 or 10–32) (1) to fasten the shipping bracket (2) to the front of the
server.
Insert the short screws into the four empty storage holes on the shipping bracket.
They will be stored there to be used when you remove the shipping bracket.
If you are installing the shipping brackets in a rack with square holes, check to ensure that the
cage nuts are installed in the rear.
Note the orientation and location of the cage nuts for the shipping bracket.
■
There are four cage nuts per side (eight total).
■
They are installed on the inside of the rack, facing outward. This is the opposite direction
from the cage nuts for the shelf adapter brackets.
■
For each shipping bracket, there should be two shipping bracket cage nuts; one in the hole
directly above the shipping bracket cage nut, and one in the third hole above the shipping
bracket cage nut.
If the cage nuts are not in place, you must:
a. Remove the server and the mounting hardware from the rack, as described in “Removing
the Server From the Rack”on page 85 .
1
2
4
5
6
Removing and Installing the Standard Rack Mounting Kit Shipping Brackets
43