Sun Microsystems Enterprise Tape Library 7/3500, Field Service Manual

Page: 227 / 242

Appendix B Sense Data Values 197
5 8A 02 UNCALIBRATED POSITION
System requires calibration.
Both
B 8C 01 LOAD PORT TIMEOUT
The door was unlocked but did not leave its
current position before time-out (30
seconds). This may be due to the door being
stuck, or in the case of a close operation, the
operator not moving the door.
Both
4 8C 06 LOAD PORT DOOR OPEN
The door is stuck in an intermediate position
(not opened and not closed.) Operation
intervention is required.
Both
B 8D 01 DLT™ DRIVE HANDLE MOTOR TPU
TIMEOUT
Replace robotics controller board.
Both
B 8D 02 DLT DRIVE HANDLE MOTOR MOVE
TIMEOUT
Retry command. If failure repeats, power
cycle unit. If failure repeats, run DLT Drive
Handle self-test.
Both
4 8D 03 DLT DRIVE HANDLE MOTOR CPU RAM
ERROR
Replace robotic controller board.
Both
4 8D 04 DLT DRIVE HANDLE MOTOR CPU
REGISTER ERROR
Replace robotic controller board.
Both
4 8D 05 DLT DRIVE HANDLE MOTOR
HARDWARE ERROR
Stepper was unable to reach destination
(open or close). Retry command. If failure
repeats, run DLT Drive Handle self-test.
Both
TABLE B-1
Sense Data Values (Hexadecimal) (Continued)
Sense
Key
ASC ASCQ Message Name/Description Interface