Sun Microsystems Enterprise Tape Library 7/3500, Field Service Manual

Page: 210 / 242

180 Sun Enterprise Tape Library 7/3500 Field Service Manual • July 1997
Systest Library
The Systest Library command is used to test the library (
FIGURE A-15
).
FIGURE A-15
Systest Library Screen
▼
To Test Library Operation
1. Press the Systest Library button on the Service screen.
The Systest Library screen is displayed.
2. Select which bins and/or drives to test:
■
To test storage bins only, press the Swap Bins button. You can then use the keypad and
Select button to specify the number of bins to test. If you press Select without entering a
number, all bins are tested.
■
To test drives only, press the Swap Drives button.
■
To test both bins and drives, press both the Swap Bins and Swap Drives buttons.
3. Select the desired test options:
■
To swap cartridges at random, press the Random button. (If this button is not pressed,
cartridges are swapped sequentially from the first bin or drive.
■
To have the library read the bar code as it swaps a cartridge, press the Use Barcodes
button.
■
To have the test repeat continually until aborted, press the Continuous button. (If this
button is not pressed, the test runs one time and then stops.
4. Press the Execute button to begin the test.
The test continues until completed or until the Abort button is pressed. If you pressed the
Continuous button, you must press Abort to stop the test.
S
Load Port
Stop
Standby
Home Back Forward
System
Offline
Tapes Overview Operator Service Service
Test: Systest Library
_
Random
Swap Bins
Swap Drives Continuous
Execute Use Barcodes
#of Bins:
1 2
3 4
5 6
7 8
9 0
Select