Subaru 2004 LEGACY, Service Manual

Page: 63 / 609

WT-6
WHEEL AND TIRE SYSTEM
Aluminum Wheel
4. Aluminum Wheel
A: REMOVAL
Refer to “Steel Wheel” for removal procedure of
aluminum wheels. <Ref. to WT-5, REMOVAL,
Steel Wheel.>
B: INSTALLATION
Refer to “Steel Wheel” for installation procedure of
aluminum wheels. <Ref. to WT-5, INSTALLATION,
Steel Wheel.>
C: INSPECTION
Refer to “Steel Wheel” for inspection procedure of
aluminum wheels. <Ref. to WT-5, INSPECTION,
Steel Wheel.>
Rim runout:
D: CAUTION
Aluminum wheels are easily scratched. To main-
tain their appearance and safety, do the followings:
1) Do not damage the aluminum wheels during re-
moval, installation, wheel balancing, etc. After re-
moving the aluminum wheels, place them on a
rubber mat, etc.
2) While driving the vehicle, be careful not to ride
over sharp obstacles or allow aluminum wheels to
contact the shoulder of the road.
3) When installing a tire chain, be sure to install it
properly not to have slack, otherwise it may hit the
wheel while driving.
4) When washing the aluminum wheel, use neutral
synthetic detergent and water. Avoid using the
cleanser including abrasive, hard brushes or an au-
tomatic car washer.
Axial runout limit Radial runout limit
1.0 mm (0.039 in)