Subaru 2004 LEGACY, Service Manual

Page: 556 / 609

PS-37
POWER ASSISTED SYSTEM (POWER STEERING)
Steering Gearbox [LHD Model]
Installed tie-rod length L:
31 mm (1.22 in)
37) Inspect the gearbox as follows:
“A” Holding the tie-rod end, repeat lock to lock two
or three times as quickly as possible.
“B” Holding the tie-rod end, turn it slowly at a radius
one or two times as large as possible.
After all, make sure that the boot is installed in
specified position without deflation.
38) Remove the gearbox from ST.
ST1
926200000 STAND
ST2 34199AG000 BOSS D
39) Install the four pipes on gearbox.
(1) Connect the pipe A and B to four pipe joints
of gearbox.
Tightening torque:
13 N
⋅
m (1.3 kgf-m, 9.4 ft-lb)
(2) Connect the pipe C and D to gearbox.
Tightening torque:
Pipe C: 15 N
⋅
m (1.5 kgf-m, 10.8 ft-lb)
Pipe D: 25 N
⋅
m (2.5 kgf-m, 18.1 ft-lb)
2. CONTROL VALVE ASSEMBLY
Specified steering grease:
VALIANT GREASE M2 (Part No. 003608001)
1) Clean all parts and tools before reassembling.
2) Apply a coat of specified power steering fluid to
the inner wall of valve housing.
3) To avoid scratching the oil seal, apply a coat of
grease to the contact surface of installer and oil
seal.
4) Verify the oil seal direction.
Attach the oil seal to installer and position in valve
housing before pressing into place.
PS-00097
L
PS-00098
B
A
(1) Pipe C
(2) Pipe D
(1) Apply fluid.
PS-00525
(1)
(2)
PS-00169
(1)