Subaru 2004 LEGACY, Service Manual

Page: 593 / 609

PS-74
POWER ASSISTED SYSTEM (POWER STEERING)
Pipe Assembly [RHD Model]
5) Temporarily connect the return hose and pres-
sure hose to gearbox. Place the clamp E in the po-
sition shown in the figure, and tighten the bolt
temporarily.
NOTE:
Ensure that the letter “8” on each clamp are diago-
nally opposite each other as shown in the figure.
6) Tighten the clamp E.
Tightening torque:
7.4 N
⋅
m (0.75 kgf-m, 5.4 ft-lb)
7) Tighten the joint nut.
Tightening torque:
15 N
⋅
m (1.5 kgf-m, 10.8 ft-lb)
8) Connect the pipe A and B to the four pipe joints
of gearbox.
Tightening torque:
13 N
⋅
m (1.3 kgf-m, 9.4 ft-lb)
9) Install the front crossmember support plate and
jack-up plate.
10) Lower the vehicle.
11) Tighten the bolts which hold the hose bracket.
Tightening torque:
13 N
⋅
m (1.3 kgf-m, 9.4 ft-lb)
12) Install the air intake duct.
<Ref. to IN(H4DOTC)-9, INSTALLATION, Air In-
take Duct.> <Ref. to IN(H4SO 2.0)-9, INSTALLA-
TION, Air Intake Duct.>
13) Connect the battery ground cable to battery.
14) Feed the specified fluid.
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
(1) Return hose
(2) Pressure hose
(3) Approx. 27 mm (1.06 in)
(4) Clamp E
(1) Clamp E
(2) Pipe C
(3) Return hose
PS-00467
(1)
(2)
(3)
(4)
PS-00540
(2)
(1)
(3)
(1) Pipe A
(2) Pipe B
(1) Hose ASSY
(2) Hose bracket
PS-00446
(1)
(2)
PS-00451
(1)
(2)