Subaru 2004 LEGACY, Service Manual

Page: 479 / 609

BR-20
BRAKE
Front Disc Brake Assembly
4. Front Disc Brake Assembly
A: REMOVAL
1. 15-INCH TYPE
CAUTION:
Do not allow brake fluid to come in contact with
vehicle body; wash away with water and wipe
off completely if spilled.
1) Lift-up the vehicle, and remove the front wheels.
2) Remove the union bolt, and disconnect the
brake hose from caliper body assembly.
3) Remove the bolt securing lock pin to caliper
body.
4) Raise the caliper body, and then move it toward
vehicle center to separate it from support.
5) Remove the support from housing.
NOTE:
Remove the support only when replacing itself or
rotor. It need not be removed when servicing the
caliper body assembly.
6) Clean mud and foreign particles from the caliper
body assembly and the support.
2. 16-INCH TYPE
Refer to 15-inch type. <Ref. to BR-20, 15-INCH
TYPE, REMOVAL, Front Disc Brake Assembly.>
3. 17-INCH TYPE
Refer to 15-inch type. <Ref. to BR-20, 15-INCH
TYPE, REMOVAL, Front Disc Brake Assembly.>
B: INSTALLATION
1. 15-INCH TYPE
1) Install the support on housing.
Tightening torque:
80 N
⋅
m (8.2 kgf-m, 59 ft-lb)
2) Apply a thin coat of Molykote M7439 to the pad
clip.
3) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to the frictional portion between pad
and inner shim.
BR-00021
BR-00022
BR-00023
BR-00340
BR-00238