Strebel S-CB+ Series, Installation Operating & Maintenance Manual

Page: 123 / 125

S-CB
+
Boiler Range Manual
123
20 INDEX
0-10 vdc remote burner input con-
trol, 82
0-10 vdc remote flow temperature
set point, 81
3-way valve (diverter valve), 9, 37,
83
accessories, 14
accessories and unpacking, 12
adjusting and setting the burner, 93
air separator, 21 ff.
air supply, 15, 28
air venting, 19, 20
Ambassador
+
60-120, 12
Ambassador
+
150-180, 13
anti-Legionnaires
’ disease (pas-
teurisation) function, 85
article numbers, 14
automatic air vent, 20
automatic water filling systems, 20
B23P boilers, 29
blocking, 19, 37, 74, 80, 90, 102,
113
boiler connections, 17
boiler room, 15
by-pass, 18
C63 boilers, 29
checking the fault history, 61
checking the operating history, 60
cleaning of the burner, 113
closed boiler, 15, 28
combustion air quality, 28
commissioning the boiler, 87
connections electric, 37 ff.
connections gases miscellaneous,
26 ff.
connections water miscellaneous,
17 ff.
control panel / display unit, 43
control panel menu structure, 44
controlling behaviour settings, 80
controlling options and settings, 78
dimensions, 12
dirt filter, 21 ff.
dirt separator, 21 ff.
display during operation, 46
diverter valve (3-way valve), 9, 37,
83
e-bus interface, 14
efficiency, 9
electrical connections, 37
electrical installation, 37
electrical schematics, 39
expansion vessel, 18
extra boiler control, 78
fan, 15, 49, 78, 101, 113
fault checking, 61, 74
fault codes display, 74
fault codes. blocking codes, 102
firing for the first time, 92
flue gas and air supply examples, 29
flue gas and air supply systems, 26
flue gas duct, 28
flushing with clean water, 21
frame, 16
frost protection, 19
gas conversion, 98
gas valve, 14, 93 ff, 101, 113
hanging level, 16
heat exchanger, 9, 84 ff, 113
heating, 78 ff.
heating and hot water switching at
sudden temperature drop, 85
heating and hot water switching
time, 85
hydraulic graphs, 24
hysteresis, 80
ignition, 113
indirect hot water / calorifier, 83
inspection & maintenance, 113
installation examples, 21, 118 ff.
installation of the Ambassador
+
, 15
installing a strainer and/or dirt sepa-
rator, 19
introduction, 9
legonnaires' disease, 53, 85
low loss header, 18, 21, 90
low/high flow temperature to tank
coil, 84
low-water level protection, 15
Ls and Lw gases, 93 ff, 96
maintenance, 113
master, 9, 56
max cooling time, 78
modulation, 14, 118 ff.
monitor screens, 47
night shift, 56, 82
non return valve, 118 ff.
offset, 80
outdoor graph, 56
outdoor sensor (outdoor tempera-
ture), 14, 37, 38, 56
outdoor temperature control, 56
oxygen, 19 ff.
oxygen diffusion proof, 90
oxygen tight, 90
password, 67
plastic piping in the heating system,
20
positioning the boiler, 16
power (supply), 9, 18, 37, 90
pressure relief valve, 18
pressure safety valve, 90
printed circuit board, 39
pump, 18
pump and 3-way valve control, 83
putting the boiler out of operation,
101
quality of combustion air, 28
quality of used water, 19
reset, 74
roof mounted duct, 28
room thermostat on/off, 81
room thermostat open therm, 81
safety guidelines, 7
schornsteinfeger function, 48
sensor, 14, 19, 20, 37, 56, 80, 83,
118 ff.
sensor values, 38
service function, 49
set points, 52
setting at the maximum load, 93 ff.
setting at the minimum load, 93 ff.
setting the maintenance specifica-
tions, 62
setting the outdoor specifications, 56
setting the parameters with the
display menu, 67
setting the time & date, 51
setting the timer programs, 53
starting the boiler, 92
stationing the boiler, 16
status, 46
tank sensor, 83
tank thermostat, 83
technical data Ambassador
+
boilers,
9
temperature display on/off, 78
timer contact function, 82
under floor heating, 21
unpacking, 14
user instructions, 117
user manual, 9, 15
valve, 92 ff, 93 ff, 113
ventilate, 7, 15
venting, 7, 15, 19, 20, 113
wall mounted duct, 16, 21
water pressure, 20
water pressure switch, 37, 90
water quality, 19
water side connections, 17
water treatment, 21
weather dependent control, 56, 81