Reference
N-14
®
Notes
10MAY01
4.
Insert the tip of the grease gun into the small, flush miniature fitting on
the X-axis bearing housing (see illustration below).
5.
Pump the grease gun handle three times, or until the bearing is full. The
bearing is full when grease starts oozing from the upper center of the
bearing housing.
6.
Wipe off any excess grease.
Step 2—Grease the Rear X-axis Bearing on the 8000
1.
Move the head to the right front corner of the envelope.
2.
Access the rear of the head carriage assembly and insert the tip of the
grease gun in the small, flush miniature fitting in the rear bearing hous-
ing (see illustration below).
3.
Pump the grease gun handle three times, or until the bearing is full. The
bearing is full when grease starts exiting the upper center of the bearing
housing.
4.
Wipe away any excess grease.
5.
Reset the temperatures on the Watlows.
Rear grease
fitting
Rear bearing
housing
XY Table
(rear view)
Summary of Contents for FDM 2000
Page 1: ...Introduction FDM 2000 3000 8000 Release 2 0 Stratasys Document no 105208 0001 Rev B...
Page 17: ...Contents FDM 2000 3000 8000 Manual 10 MAY 01 F2 3 8000 vi...
Page 105: ...Reference N 2 Notes 10MAY01 Release 1 0 October 1997 5 0 May 2001...
Page 131: ...G 1 Reference Glossary 10MAY01 Release 4 0 Glossary Stratasys Document no 105213 0001 Rev B...
