Stock DISOCONT Tersus DT-9, Configuration And Operation Manual, Page: 3 / 158

DISOCONT® Tersus (DT-9) Configuration and Operations Manual
©Schenck Process Group
i
1 ABOUT THIS MANUAL ......................................................................................... 5
2 SAFETY INSTRUCTIONS ...................................................................................... 7
3 OVERVIEW............................................................................................................. 9
3.1 What is the DISOCONT Tersus/DT-9? .......................................................................................... 9
3.2 Definitions ....................................................................................................................................... 9
3.3 Measuring Principle ..................................................................................................................... 10
3.4 Operating Modes - Remote.......................................................................................................... 12
3.4.1 Gravimetric............................................................................................................................... 12
3.4.2 Volumetric ................................................................................................................................ 12
3.4.3 Volumetric Control ................................................................................................................... 12
3.5 Operating Modes – OFF/Maintenance ........................................................................................ 12
4 DT-9 SETUP ......................................................................................................... 13
4.1 Setup Notes................................................................................................................................... 13
4.2 Startup and Functional Check..................................................................................................... 14
4.3 Setup Parameters ......................................................................................................................... 15
4.3.1 Commonly Changed Parameters ............................................................................................ 15
4.4 Calibration ..................................................................................................................................... 17
4.4.1 Performing Calibrations ........................................................................................................... 18
4.4.2 Weigh Roller Adjustment ......................................................................................................... 19
4.4.3 Basic (CAL 1) ........................................................................................................................... 20
4.4.4 Span (CAL 2) ........................................................................................................................... 22
4.4.5 TC: Span Calibration................................................................................................................ 24
4.4.6 LB: Pulses per Belt .................................................................................................................. 25
4.4.7 TA: Tare ................................................................................................................................... 25
4.5 Analog Trim................................................................................................................................... 27
5 OPERATION USING THE TOUCH SCREEN HMI ............................................... 29
5.1 Initial Configuration...................................................................................................................... 29
5.1.1 The “Network” Screen.............................................................................................................. 30
5.1.2 The “Display Settings” Screen ................................................................................................. 30
5.1.3 The “Feeder” Screen................................................................................................................ 30
5.1.4 The “Configuration” Screen...................................................................................................... 30
5.1.5 The “Communication” Screen .................................................................................................. 30
5.1.6 The “Calibration” Screen.......................................................................................................... 31
5.1.7 Exiting HMI Configuration ........................................................................................................ 31