stertil-KONI Freedomlift SK 2055, Installation And Service Manual

Page: 64 / 118

Installation and Service Manual 64 SK 2055 / 2070 / 2090
3. Determine what height the overhead wiring needs to be at and adjust the
vertical connecting tubes (2) to the correct length, if necessary.
4. Pull the hydraulic hose and electrical cables through the tubes (1 and 2)
and supports (3).
The hydraulic hose's elbow joint should be attached to the hydraulic unit of
post I and the two loose cables need to be connected up to post II.
5. Fit the pre-assembled connecting tubes plus hydraulic hose and electric
cables onto the posts.
6. Remove the cap and connect the hydraulic hose to the hydraulic unit (post
I).
7. Remove the cap and attach the other end of the hydraulic hose to the line
for the lifting cylinder (post II).
8. Attach the electric cable in post I using the plugs for the control box.
9. Thread the electric cables through the cable duct in the pillar and connect
them to the cables in the cable trough (post II).
2
5
8
7
1
2
3
4
5
6
7
8
1. Wiring for post II
2. Cable clamp
3. Plugs for control valves
4. Wiring for post I
5. Cable in cable trough