Steris Cmax, Operator'S Manual

Page: 109 / 218

6-4
764333-268
Figure 6-2. Table Sensor Calibration
26. Press REV. ORIENT button to save setting.
Display shows TILT R MAX .
27. Use REVERSE TREND button to return table to
near level. Do not use LEVEL button.
28. Display shows TILT R MAX . Tilt to maximum
right tilt.
29. Press
REV. ORIENT
button to save setting.
30. Display shows TILT L MAX . Tilt to maximum left
tilt.
31. Press REV. ORIENT button to save setting.
Display shows BACK D MAX .
32. Use TILT RIGHT button to return table to near
level. Do not use LEVEL button.
33. With display showing BACK D MAX , lower back
to maximum down position.
34. Press REV. ORIENT button to save setting.
35. Display shows
BACK U MAX
. Raise back to
maximum up position.
36. Press REV. ORIENT button to save setting.
Display shows LEG D MAX .
37. Use Back Down function to return table to near
level. Do not use LEVEL button.
38. With display showing LEG D MAX , lower leg to
maximum down position.
39. Press REV. ORIENT button to save setting.
40. Display shows LEG U MAX . Raise leg to
maximum up position.
41. Press
REV. ORIENT
button to save setting.
Display shows
RESET ALARM
.
42. Use Leg Down function to return table to near
level. Do not use LEVEL button.
43. With display showing RESET ALARM , press
REV. ORIENT button to reset all sensor alarms.
NOTE: Calibration data is lost if you fail to press
REV. ORIENT button in this step.
Important: Do not press the LEVEL button until
Step 45 is performed.
44. Hand control exits LEVEL/ADJUST MODE.
45. Press
OFF
button to turn power OFF. Press any
button (but
OFF
) to turn power ON.
46. Verify table returns to level correctly from all
positions, including Flex and Reflex.
47. Verify all ALS functions.
Tilt frame
Extend
Tab
Sid
Inn
Tabletop
Side Member
Inner Face
Tilt Frame
Extend Tabletop
3/16" (4.8 mm)
Beyond Foot
End of Tilt Frame
NOTE: Tabletop removed for clarity only.