Stride Belt Replacement
Remove and
install ONL Y
stride belt at
a
time.
Tools Required:
Phillips head screwdriver
7/16-in. socket or open-end wrench
1/2-in. socket wrench
1/2-in. open-end wrench
3/16-in. Allen wrench
1/8-in. Allen wrench
Needle nose pliers
Remove the rear shroud:
1.
Using Phillips head screwdriver, remove the eight Phillips head screws from the rear
shroud.
2.
Lift the rear shroud off the unit.
Remove the stride belt:
1.
Using needle nose pliers, CAREFULLY pull the two cotter pins out from the belt tension
pulley (at the rear of the unit).
2.
Using needle nose pliers, CAREFULLY pull the belt tension anchor pin out from the belt
tension pulley. See Diagram R.
\
I
\
I
REMOVE/
Diag. R
----
\
/
5.20
Elliptical
Service Manual
Summary of Contents for Elliptical Edge
