StarTrac Elliptical Edge, Service Manual

Page: 46 / 74

Skate Rail Replacement>
NOTE: It may be nec-
essary to adjust stride
belt tension following
skate rail replacement
(see Section
2 for de-
tails).
NOTE: You may need
to adjust the shuttle to
remove
excess side-
play (see Section 2 for
details).
19. Using 3/16-in. hex head socket wrench, secure the shuttle to the capture plate with the
four screws. TIGHTEN THE SCREWS SECURELY.
20. Route the free end of the stride belt around the belt tension pulley, and insert through the
pulley opening.
21. Insert the belt tension anchor pin in the belt tension pulley through the loop in the stride
belt. Install the two cotter pins in the belt tension anchor pin
22. Place the footpad in position on the shuttle. Using 3/16-in. hex head socket wrench, install
the four Allen screws (from underneath the shuttle) to secure the footpad to the shuttle.
TIGHTEN THE SCREWS SECURELY.
Install the rear shroud:
1. Install the rear shroud in position on the unit.
2. Using Phillips head screwdriver, secure the rear shroud to the unit with the eight Phillips
head screws.
Install the front shroud:
1. Install the front shroud in position on the unit.
2. Using Phillips head screwdriver, secure the front shroud to the unit with the eight
head screws.
Elliptical Edge Service Manual
5.19