StarTrac Elliptical Edge, Service Manual

Page: 34 / 74

Cable Harness Replacement
Tools Required:
Phillips head screwdriver
1/2-in. open-end wrench
Needle-nose clippers
Tie straps (20 req'd)
Remove the front shroud:
1. Using Phillips head screwdriver, remove the eight Phillips head screws from the front
shroud.
2. Lift the front shroud off the unit.
Disconnect the cable harness from the LeB:
NOTE: DO NOT pull on
the wires when discon-
necting the cables from
the LeB.
1. CAREFULLY disconnect the following cables from the LCB by grasping and pulling the
cable connectors: See Diagram D.
• Disconnect the battery cable from LCB connector J3.
• Disconnect the alternatorlload resistor cable LCB connector J4.
\
/
/
Diag. D
Disconnect the external power cable LCB connector J5.
•
Disconnect the cable harness from the alternator:
1. Using 1/2-in. open-end wrench, disconnect the following wires from the alternator termi-
nals:
• Disconnect the two red wires from the alternator B terminal.
• Disconnect the black wire from the alternator E terminal.
Elliptical Edge Service Manual 5.7