Preventive Maintenance Chart
The Preventive Maintenance Chart lists the scheduled maintenance tasks for the Elliptical Edge. The chart lists the
time interval when each procedure should be performed, and provides the general steps necessary to perform the
task. In some cases, the chart references detailed maintenance procedures provided later in the section.
D
=
Daily; W
=
Weekly; Q
=
Quarterly (depending on the amount of use, Quarterly procedures may need to
be performed more frequently).
INTERVAL
D
W
Q
PROCEDURE
•
Clean dust and dirt from the unit using a soft, clean cloth dampened with a non-abrasive liquid
cleaner. Give particular attention to the display panel, handrails and heart rate grips (if used).
•
Clean dust, dirt, oils or other contaminants from inside the skate rails (the shuttle tracks), and on
the shuttle rollers, using a soft, clean cloth and a non-abrasive liquid cleaner. If needed, remove
stubborn accumulations by scrubbing with a soft-bristle brush (such as a toothbrush). NEVER use
a wire brush or any abrasive material to clean the skate rails or shuttle rollers.
IMPORTANT: Regular cleaning of the skate rails and shuttle rollers is CRITICAL to proper op-
eration of the unit. Accumulations of dust and dirt on the skate rails or shuttle rollers can result in
rough operation, misalignment of the shuttles and excessive wear on the skate rails and shuttle
rollers.
•
Vacuum the floor under and around the unit. MAKE SURE that the unit is at its maximum eleva-
tion when vacuuming (or move the unit to another location).
•
Check the display panel and handrails to ensure they are securely attached to the unit. Retighten
the screws as needed.
•
Inspect the Sport Utility Display panel for evidence of wear. Contact STAR TRAC Customer
Support if replacement of the Sport Utility Display panel is necessary.
•
Check each shuttle for misalignment or excessive sideplay. Realign the shuttles as needed (see
Shuttle Alignment, page 2.3).
•
Check each stride belt for proper tension. Adjust the stride belt tension as needed (see Adjusting
Stride Belt Tension, page 2.4).
•
Check the crank belt for proper tension. Adjust the crank belt tension as needed (see Adjusting
Crank Belt Tension, page 2.5).
2.2
Elliptical Edge Service Manual
Summary of Contents for Elliptical Edge
