StarTrac Elliptical Edge, Service Manual

Page: 44 / 74

Skate Rail Replacement
-
NOTE: Adjust the posi-
tion of the skate rail as
needed to allow re-
moval of the crank arm
shaft.
9. Using 1/2-in. hex head socket wrench and 1/2-in. open-end wrench, remove the rear
stride belt pulley (and bolt) from inside the skate rail.
See Diagram O.
/
/
Diag.O
10. Using 1/2-in. hex head socket wrench and 1/2-in, open-end wrench, remove the front
stride belt pulley (and bolt) from inside the skate rail.
See Diagram P.
BELT PULLEY
o
Diag. P
11. Pull the stride belt out through the back of the skate rail.
12. Using 5/32-in. Allen wrench, remove the two Allen screws from the crank arm.
13. CAREFULLY slide the crank arm shaft and two nylon washers out of the skate rail. BE
CAREFUL not to lose the
nylon washers. See Diagram Q.
Diag.Q
Elliptical Edge Service Manual 5.17