Transmission Bearings Replacement
Tools Required:
Phillips head screwdriver
9/16-in. socket wrench
9/16-in. open-end wrench
3/32-in. Allen wrench
Rubber mallet
Belt tensioner gauge
Remove the front shroud:
1.
Using Phillips head screwdriver, remove the eight Phillips head screws from the rear
shroud.
2.
Lift the rear shroud off the unit.
Remove the transmission assembly:
NOTE:
If needed,
GENTL Y tap the
transmission pulley
with
a
rubber mallet to
remove from the
"ansmission shaft.
5.24
1.
Using 9/16-in. open-end wrench, loosen the transmission idler tension nut and bolt so the
crank belt is completely loose. See Diagram X.
LOOSEN
LOOSEN
Elliptical Edge Service Manual
Summary of Contents for Elliptical Edge
