Stride Belt Replacement
I N C . _
•
NOTE:
It
may be nec-
essary to adjust stride
belt tension following
belt replacement (see
Section
2
for details).
NOTE: You may need
to adjust the shuttle to
remove excess side-
play (see Section
2
for
details).
holes out through the access hole in the side of the skate rail.
6.
Assemble the capture plates on the stride belt, aligning the holes in the capture plates
with the holes in the stride belt.
7.
Using 1/8-in. Allen wrench, secure the capture plates to the stride belt with the three Allen
screws. Insert the stride belt and capture plate back inside the skate rail.
8.
Remove any extra slack from the stride belt by GENTLY pulling the stride belt out the rear
of the skate rail. MAKE SURE the stride belt is tight around both the front and rear stride
belt pulleys.
9.
Insert the exposed end of the stride belt through the groove in the belt gUide bracket.
10. Using 7/16-in. hex head socket wrench and 3/16-in. Allen wrench, secure the belt guide
bracket to the frame with the two bolts. TIGHTEN THE BOLTS SECURELY.
11. Slide the shuttle back along the skate rail and align the four holes in the rear of the shuttle
with the four holes in the capture plate.
12. Using 3/16-in. hex head socket wrench, secure the shuttle to the capture plate with the
four screws. TIGHTEN THE SCREWS SECURELY.
13. Route the free end of the stride belt around the belt tension pUlley, and insert through the
pulley opening.
14. Insert the belt tension anchor pin in the belt tension pUlley through the loop in the stride
belt. Install the two cotter pins in the belt tension anchor pin
15. Place the footpad in position on the shuttle. Using 3/16-in. hex head socket wrench,
the four Allen screws (from underneath the shuttle) to secure the footpad to the shuttle.
TIGHTEN THE SCREWS SECURELY.
Install the rear shroud
1.
Install the rear shroud in position on the unit.
2.
Using Phillips head screwdriver, secure the rear shroud to the unit with the eight Phillips
head screws.
Elliptical Edge Service Manual
5.23
Summary of Contents for Elliptical Edge
