StarTrac Elliptical Edge, Service Manual

Page: 29 / 74

Tools Required:
3/32-in. Allen Wrench
Remove the display panel:
Display Panel Replacement
NOTE: Use one hand
to support the display
panel during removal.
NOTE: DO NOT pull
on the wires when dis-
connecting the cable
from the display
panel.
NOTE: Use one hand
to support the display
panel during installa-
tion.
NOTE: The cable con-
nectors are keyed to
'ent improper con-
.ion.
5.2
1. Using 3/32-in. Allen wrench, remove the seven Allen screws from the back of the display
panel. BE SURE to support the display panel after the Allen screws have been removed.
2. CAREFULLY disconnect the communication cable from display panel connector J4 and
the display power cable from display panel connector J7, by grasping and pulling the ca-
ble connectors.
3. Remove the display panel.
Install the display panel:
1. Place the display panel in position on the unit. BE SURE to support the display panel until
the Allen screws have been installed.
2. CAREFULLY connect the communication cable and power cable to the display panel.
MAKE SURE the connectors are properly aligned when reconnecting. DO NOT force the
connectors.
• Connect the communication cable to display panel connector J4.
• Connect the display power cable to display panel connector J7.
3. Using 3/32-in. Allen wrench, secure the display panel to the frame with the seven Allen
screws. Tighten the Allen screws firmly. DO NOT OVERTIGHTEN.
Elliptical Edge Service Manual