Star Micronics TSP400 Series, Programmer'S Manual

Page: 49 / 136

– 46 –
PAGE MODE
EXAMPLE 2
LPRINT CHR$(&H1B);“#1,1111”;CHR$(&H0A);CHR$(&H00);
LPRINT CHR$(&H1B);“?”;CHR$(&H0A);CHR$(&H00);
Sensor : Transmissive sensor
Start position detect : ON
Zero style : Slashed zero
International character set : France
EXAMPLE 3
LPRINT CHR$(&H1B);“#2,0001”;CHR$(&H0A);CHR$(&H00);
LPRINT CHR$(&H1B);“?”;CHR$(&H0A);CHR$(&H00);
Cutter : Invalid
Printing speed : 25 mm/sec
Note: In order to enable the changed memory switch setting,
turn the printer OFF and ON again or send the printer
reset command (<ESC>“?”) to the printer.
FUNCTION
Reset printer
CODE
<ESC> ? <LF><NUL>
HEX
1B 3F 0A 00
REMARKS
Resets the printer and prints self-test. This command will also set
memory switch conditions without the need to turn the printer
power OFF and ON again.
EXAMPLE
LPRINT CHR$(&H1B);“?”;CHR$(&H0A);CHR$(&H00);
FUNCTION
Request status
CODE
<ENQ>
HEX
05
REMARKS
When the printer receives this command, the printer sends back a
status byte for the current printer condition immediately to the
host.
Note: Printer conditions are reported by the following status
bytes: