– 8 –
4-3. Connectors and Signal Names
4-3-1. RS-232C Interface
Pin no
Signal name
Direction
Function
1
F-GND
–
Frame ground
2
TXD
OUT
Outgoing data
3
RXD
IN
Incoming data
4
RTS
OUT
Request To Send: The printer sets this signal
to “SPACE” when it is ready to send.
5
CTS
IN
The host sets this signal to “SPACE” when it
is ready to send. NOTE: The printer does not
monitor this signal.
6
N/C
Not used
7
S-GND
–
Signal ground
8
N/C
Not used
9 ~ 10
N/C
Not used
11
RCH
OUT
The printer sets this signal to “SPACE” when
it is ready to receive. This pin outputs the
same signal as pin 20, to which it is con-
nected.
12
N/C
Not used
13
S-GND
–
Signal ground.
14
FAULT
OUT
The printer sets this signal to “MARK” to
indicate an error condition (machine error, no
paper, etc.).
15
Multi-Printer TXD OUT
Diode gate TXD
16
Multi-Printer DTR OUT
Diode gate DTR
17 ~ 19
N/C
Not used
20
DTR
OUT
Data Terminal Ready: The printer sets this
signal to “SPACE” when it is ready to re-
ceive.
21 ~ 22
N/C
Not used
23 ~ 25
N/C
Not used
13
1
14
25
SERIAL
Summary of Contents for TSP400 Series
