Star Micronics TSP400 Series, Programmer'S Manual

Page: 8 / 136

– 5 –
Pause at c: command mode selection
Press ON LINE 1 short beep Page mode
Press FEED 2 short beeps Line mode
3) Power + ON LINE + FEED switches
Approx. Approx. Approx. Approx.
2 sec. 2 sec. 2 sec. 2 sec.
1 short beep … 2 short beeps … 3 short beeps … 1 long beep … …
a b c d e
HEAD UP NO PAPER ERROR LEDs flash All LEDs
LED LED LED successively light up
lights up lights up lights up lights up
Pause at a: RAM backup cleared
Pause at b: feed function selection
Press ON LINE 1 short beep Disable starting position
Press FEED 2 short beeps Enable starting position
Pause at c: sensor adjustment mode
Pause at d: no operation
Pause at e: clearing of all memory switches and test print
3-4. Sensor adjustment mode
a) Reflecting sensor (black mark sensor)
• Insert the paper in front of the sensor mechanism so that the sensor is not
positioned at a black mark.
• Turn the reflecting sensor adjustment controller VR4 on the PCB until the
HEAD UP LED lights up.
b) No paper sensor
• Insert the paper in front of the sensor mechanism so that the sensor is not
positioned at a black mark.
• Turn the reflecting sensor adjustment controller VR3 on the PCB until the NO
PAPER LED lights up.
c) Transmissive sensor
• Insert only the label’s base paper in front of the sensor mechanism.
• Turn the reflecting sensor adjustment controllers VR1 and VR2 on the PCB
until the ERROR LED lights up.
• VR1 is used for coarse adjustment and VR2 is used for fine adjustment.