Star Micronics TSP400 Series, Programmer'S Manual

Page: 96 / 136

– 93 –
LINE MODE
FUNCTION
Set select mode
When using serial interface printer;
CODE <DC1> or <DC1> n
HEX
(11)H or (11)H n
When using parallel interface printer
CODE <DC1>
HEX
(11)H
REMARKS
(1) When using serial interface printer;
This function differs depending on the setting of the DIP
switch 4.
a) When the DC1, DC3 invalid mode is set (DIP switches 2-
1 to 2-4 are all set to ON), the printer ignores this code.
b) In the DC1, DC3 valid mode (with DIP switches 4-1 to 4-
4 set to OFF), when the printer receives a <DC1> code, the
deselect mode is canceled and data following this code is
input to the buffer.
c) If the printer receives a <DC1>n code (n is the DIP switch
controlled address) during the addressable mode (with DIP
switches 2-1 to 2-4 set other than settings a) and b) above,),
the deselect mode is canceled and data following this code
is input to the buffer.
Note that addressable mode is valid only when optional RS-
422A interface is installed.
(2) When using parallel interface printer;
When the printer receives a <DC1> code, the deselect mode is
canceled and data following this code is input to the buffer.
FUNCTION
Beep the buzzer
CODE
<RS>
HEX
1E
REMARKS
Sounds a brief beep tone.