Section 4: Software Commands
Page 4-18
NetClock/GTP Instruction Manual
4.10 HELP
DISPLAY
The
HELP
command lists the commonly used commands and command structure.
HELP
is available by using the following commands:
Type:
HELP <ent>
- OR -
? <ent>
Response:
SPECTRACOM CORPORATION NETCLOCK/GTP
COMMAND LIST FOLLOWS (SET MODE MUST BE ON TO CHANGE PARAMETERS)
TIME [HH:MM:SS] = CURRENT UTC TIME
DATE [YYYY-MM-DD] = CURRENT UTC DATE
LOC [D DD MM SS.sss D DDD MM SS.sss] = CURRENT LOCATION
STAT= DISPLAY STATUS INFORMATION
GSS= GPS SIGNAL STRENGTH
CONF= SHOW SETUP INFO FOR ALL OUTPUTS
SERx [BAUD FMT REQ TD DST]= SET UP SERIAL PORT
REMx [BAUD FMT TD DST]= SET UP REMOTE PORT
IRIG [TD DST]= SET UP IRIG
FPF [FMT TD DST]= FRONT PANEL SET UP
LOCK [HH:MM:SS]= GPS LOCK ALARM TIME OUT
SYNC [HH:MM:SS]= TIME SYNC ALARM TIME OUT
DSTx [RULE PARAMETERS] = SET UP DST RULES
EVNT [# CMD PARAM] = SET UP THE EVENT TIMER
ACD [XXXXXX.XXX]= ANTENNA CABLE DELAY
DAL [P] = DISPLAY ALARM LOG
DH [P] = DISPLAY HISTOGRAM LOG
SM [ON:OFF]= SET MODE
FOR FURTHER INFORMATION PLEASE CONSULT YOUR MANUAL
Additional information on the command structure is found by retrieving the command
usage message. To obtain the usage message, type the command followed by a
question mark (?). The IRIG usage message is shown below.
Type:
IRIG ?<ent>
Response:
USAGE>
IRIG [TD] [DST]
