NetClock/GPS Instruction Manual
Page 4-1
SOFTWARE COMMANDS
4.0 INTRODUCTION
From the rear panel Serial Setup Interface port the user may configure, control and
monitor the NetClock/GTP. Table 4-1 provides a listing of the command set in
alphabetical order. These commands contain a hierarchy of
Read
,
Set
and
Test
Modes
. Figure 4-1 illustrates the command structure.
Read
Mode
is the base level, this
mode the user may only view responses to commands. From
Read
Mode,
the user
may select to enter
Test
or
Set
Mode
.
Set Mode
allows the user to not only view
command responses, but configure changes to certain NetClock/GTP functions.
Test
Mode
allows the user access to special test commands, as well as all
Read
and
Set
Mode
commands. After entering
Set
Mode
or
Test
Mode
, the unit will “time out” and
return to
Read Mode
after 15 minutes of inactivity.
Read Mode:
Read Standard
Information
Test Mode:
Read or Set Standard
Plus Test Information
Set Mode:
Read or Set Standard
Information
Test Mode On
Time Out
Time Out
Test Mode On
Set Mode On
Set Mode Off
Test Mode Off
FIGURE 4-1 COMMAND STRUCTURE
