25
Chapter 2 Installation
2
Press the V button three times to select “4.SCSI”, then press the [ENTER]
button.
3
Select “Library”, then press the
[ENTER] button.
4
Set the SCSI ID and SCSI parity of the library.
1
When the “ID” of “Library” setting flashes, use the V and v buttons to set
the SCSI ID, then press the B button.
2
When the “Parity” setting flashes, use the V and v buttons to set the SCSI
parity, then press the [ENTER] button.
Select “YES” to enable the SCSI parity function.
5
In the same manner, set the Drive 2 (L).
If an AIT drive is not added, press the [ENTER] button to proceed.
6
When “[ENTER] to activate”
appears, press the [ENTER] button.
7
When “[Enter] to reset” appears,
press the [ENTER] button.
The system reboots.
Setting the Cartridges
Prepare a cartridge and set it to the AIT library.
Preparing the Cartridge
Affix the provided bar code label to the cartridge, then prepare it for use.
Note
The type of bar code label is fixed to “CODE39”. This setting cannot be
changed.
ID Parity
Library 00 YES
Drive1 01 YES
Drive2 02 YES
SCSI
12:34
ID Parity
Library 00 YES
Drive1 01 YES
Drive2 02 YES
[ENTER] to activate
SCSI
12:34
Reset the system to
activate the setting
[ENTER] to reset
Warning
12:34
