17
Chapter 2 Installation
Connecting the Power Cable
1
Confirm that the power switch on the rear of the AIT library is turned off
(a is pressed).
2
Connect one end of the power cable to the power supply connector and the
other end to the electric outlet.
Connecting to the Host Computer
Connect the AIT library and the host computer with a SCSI cable. This section
explains general connecting steps. To connect, use the Ultra Wide SCSI cable
sold at stores. The library side uses the 68-pin half pitch connector.
When connecting other SCSI devices together with the AIT Library, see
“Connecting SCSI Peripheral Devices” (page 20).
Caution
• Do not connect the AIT library to the High Voltage Differential (HVD) SCSI
bus. If connected, the library or other devices on the SCSI bus may be
damaged.
• When connecting the Wide SCSI cable, turn off all of the connecting devices,
including the host computer.
• When connecting the AIT library as the last device on the SCSI bus, be sure
to attach the provided terminator. Also, if the host computer is equipped with
a single-end SCSI host adapter, use a terminator that supports single-end.
When the wrong terminator is used, the device may be damaged.
• In Ultra Wide SCSI, make the length of the LVD (Low Voltage Differential)
SCSI cable, which connects the host computer and the device at the end of the
