2-10 (E)
BVP-E30/E30P M-V1
Drop protection
pad
Switch block
CN1005
CN1004
CN-2205 board
MENU SELECT
knob
P2.6
x
5
P2.6
x
5
Nut
Washer
SW-1069 board
Hole
SW-1070 board
Rotary encoder
(MENU SELECT knob)
Projection
Encoder bracket
B2.6
x
5
2-6. Replacing the MENU SELECT Knob/
MENU Switch/DISPLAY Switch
1.
Remove the V shoe bracket. (Refer to Section 2-5.)
2.
Remove the MENU SELECT knob.
3.
Remove the two screws, and remove the switch block
with the two harnesses connected to the CN-2205
board.
n
The drop protection pad will remove at the same time.
Be careful not to lose it.
4.
Disconnect the two harnesses from the connectors
CN1005 and CN1004 of the CN-2205 board.
5.
Remove the screw securing the SW-1069 board to the
encoder bracket, and remove the SW-1069 board.
6.
Desolder the switch to be replaced, and replace it.
7.
Remove the nut fixing the MENU SELECT knob, and
remove the SW-1070 board.
8.
Desolder the rotary encoder (MENU SELECT knob),
and replace it.
9.
Reassemble the parts in the reverse order of removal.
n
When installing the SW-1069 board, put the projection
of the encoder bracket into the hole of the SW-1069
board surely.
