24
settings
5
o
Gate travel learning process.
For use with the cells, these must be installed and aligned correctly before the
learning process (see pages 35 to 36).
the gate must be closed to carry out the learning process.
The motor’s electronics automatically store:
• The motor torque required to control the gate, in normal operation. Once this is stored, this
enables any abnormal motor effort to be detected.
• The travel distances required to fully open and close the gate with the positions of the end
stops.
During the learning process, you should remain at a normal distance from the gate and follow the
steps below:
• Press the button stored on the remote
control.
> After a few seconds, the gates will
slowly open
* If the gate does not open correctly, check
that the motors are wired as shown on
page 21
.
1
• Once the gate is open, press the button
stored on the remote control once
more.
> The gate closes, one leaf after the
other.
2
• Press the same button again.
> The gates open, still at a slow speed.
3
• Press the button one last time.
> The two leaves will close almost
simultaneously.
4
STOP
STOP
STOP
STOP
Summary of Contents for SGA 6000
