12
Preparing and drilling gateposts
1
n
steps :
o
Dimension measurement
The type of gate determines where the motors are to be placed.
Measure the dimensions described below to determine their position on the gateposts:
For these measurements, the leaves and their hinges are supposed to be on the same
axis. If the hinges are not aligned (offset), the leaves’ maximum opening angle will be
less than the values shown.
o
Dimension measurement.
o
Marking the AM and AH baselines.
o
Drilling the gateposts.
l
Measure dimension A
Using the table below, determine:
• the
maximum opening value
of the leaves,
• dimension
B
to determine the vertical
positioning axis of the motors on the
gateposts..
D
Dimension A (mm)
Maximum opening (°)
Dimension B (mm)
0
120
205
0
110
160
0
105
150
50
100
150
100
95
150
≥ 150, ≤ 250
90
150
l
Check dimensions D and L
For safety’s sake, check:
• dimension
D
which must be
greater
than or equal to 405 mm
,
• dimension
L
which must be
between
800 and 2,000 mm
.
Summary of Contents for SGA 6000
