18
Mounting the arms
3
o
Mounting the arms on the leaves.
Mounting the arms onto the gate requires drilling holes in the leaves. Complete the following
steps:
Check that the motors are in the unlocked
position .
1
Drill the leaves using an 8-mm drill
bit.
4
5
7
8
Through the fastening lug, mark the
points on the leaf bracket where holes
will be drilled.
3
Check that the gate is closed and in contact with the stop.
Push the arm fully open against the leaf.
Make sure that the fastening lug is flat against the leaf.
2
open the arm hinges completely onto the leaf
bracket. this is a guarantee that the leaf is
properly locked.
Summary of Contents for SGA 6000
