SOLZAIMA EARTH 9KW, Instruction Manual

Page: 39 / 119

38
10. Use of the pellet insert
Recommendations
Before starting up the unit, please check the following:
- Ensure the unit is properly connected to the power mains using the 230V AC power
cable.
Figure 33 – Electrical connection plug
- Check that the pellet hopper is filled. Inside the pellet reservoir is a safety grid to
prevent users from reaching the worm screw.
The unit’s combustion chamber and panel door are made o f iron plate
painted with high temperature resistant paint which releases fumes during
the initial burn due to the paint’s curing process. Avoid touching the unit
during its first burn to prevent leaving permanent marks on the paint. The
paint goes through a more plastic phase during the curing process. The curing
of the paint occurs at approximately 300ºC for 30 minutes.
Please make sure the room where the unit is installed has adequate air circulation;
otherwise, the unit will not work properly. For this reason, it is important to check if
there are any other air-consuming heating appliances present in the room (e.g. gas
units, braziers, extractors, etc.); these should not be used simultaneously with the
unit.